IP
System configuration commands
Use this command to define the maximum number of entries to keep in the ARP cache (1024, 2048, 4096, 8192, 16384, 32768).
Operational commands
show commands
See below the different parameters available for the IPv4 show command:
[email protected]:~$ show ip
Possible completions:
access-list Show all IP access-lists
as-path-access-list
Show all as-path-access-lists
bgp Show Border Gateway Protocol (BGP) information
community-list
Show IP community-lists
extcommunity-list
Show extended IP community-lists
forwarding Show IP forwarding status
groups Show IP multicast group membership
igmp Show IGMP (Internet Group Management Protocol) information
large-community-list
Show IP large-community-lists
multicast Show IP multicast
ospf Show IPv4 Open Shortest Path First (OSPF) routing information
pim Show PIM (Protocol Independent Multicast) information
ports Show IP ports in use by various system services
prefix-list Show all IP prefix-lists
protocol Show IP route-maps per protocol
rip Show Routing Information Protocol (RIP) information
route Show IP routes
reset commands
And the different IPv4 reset commands available:
[email protected]:~$ reset ip
Possible completions:
arp Reset Address Resolution Protocol (ARP) cache
bgp Clear Border Gateway Protocol (BGP) statistics or status
igmp IGMP clear commands
multicast IP multicast routing table
route Reset IP route